Installation Guides

*For additional installation instructions, please see specific product pages or contact us for more information

FloorMetAL™ Installation:

  1. Clean Thoroughly: Remove all loose debris, dirt, and grime. For best results, power wash or spray the area. If that’s not possible, use a shop vac or brush.
  2. Ensure Dry Surface: Wait until the area is completely dry before applying the decal.
  3. Apply Pressure: Use a J roller or foam roller to press firmly across all areas of the decal, ensuring no moisture gets underneath. Finish by applying pressure with your hands.
  4. Optional Permanent Seal: For a more permanent hold, apply a concrete primer or sealer (available at hardware stores) before installation. Afterward, seal the edges with 2-part epoxy and trim any seams to protect against water damage.

GGGrips™ Installation

  1. Remove loose debris from surface area before applying graphic. Power washing and/or using a shop vac is ideal for clean-floor graphics installation.
  2. Remove backing liner from decal
  3. Apply decal using pressure and remove any bubbles that may form